on a manual window you need to pull the door panel off than you can access the window regulator, the glass is bolted to the regulator, you may need to crank the window up or down to get to the bolts, I beleave the glass is attached to the regulator with 2 or 3 bolts, replacing is the reverse.
help with removing the door panel from http://www.neons.org/howtos/door/ The first step to removing the door panel is to remove the window crank. There is a special U clip that holds the window crank unto a groove on the window crank shaft. You must remove this clip before you can do anything else on the panel. This clip can be easily removed as shown with a door handle removal tool, or with a very flat screw driver or piece of metal. Once this clip is removed then the door window crank should come off easily. Next you must remove two other screws. One is in the door pull cup (may look different on other neons, I know mine is facing up not back) and the other is behind the latch release handle. The one in the pull cup requires a screw driver, but the one in the door latch release handle requires a torx bit. Once these three things are removed, then the panel may be removed by pulling the edge of the panel out from the bottom of the door. Work your way around and up. You may then lift the panel slightly to remove it from the top of the door. Next you have to unclip the rod that connects the door latch to the door latch handle. You should now be able to remove the panel completely.
start by taking the door panel off
replace it, it should just pop out of the console
nthow to change the beltson the dodge neon
How do you replace a slave cylinder on a 1995 dodge neon clutch
The battery is under the hood on the driver side in a Dodge Neon.
A 2000 Dodge Neon does not have a maf sensor.
A 2005 Dodge Neon does not have a cabin filter.
Almost any Auto Part Store has a Window Crank remover I paid like 5 bucks for one.
I was told by the dealer that the 2002 Dodge Neon does not have a servicable fuel filter.
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
Pull out the U-clip located on the base of the window crank.
remove the clip retaining crank to the regulator shaft, this requires a special tool available at most parts houses.