This is actually a bit of a pain to do. Take apart the gauge cluter housing part of the dash. Pop off the knob for the light switch. From the back of the plastic panel, unhook the little thing that holds it in. Unplug the wires and reverse the order. While you have it apart, make sure to clean all the dust and the grooves where you can quite reach with a cleaning rag when its all put together.
Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.
You must mean 86 Bronco II? There is no 96 model.
pull the fuse
you have to drop the tank its mounted to the top
On a 1996 Ford Bronco : The fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell by ( or behind ) the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the passengers right foot
On a 1996 Ford Bronco : I believe the fuel pump inertia switch ( shut off switch ) is located in the front passenger footwell , behind the kick panel * the kick panel is the interior trim panel , in front of the front door , beside the passengers right foot
check your brakes
check your brake lights if they not worhing replace fuse or brake light switch
on the brake pedal under the dash there will be a king pin pull it out and remove the stud and the switch should come right out then dosconnect the wireing harness and replace switch
where is the brake light switch for 1996 Oldsmobile cutlas supreme
The combination neutral start and backup light switch is mounted inside the shifter housing. Remove the screws holding down the shifter housing and remove the switch. Adjust the switch by moving it on its mounts.
Ignition what? Switch? Coil?