For a 2003 sebring convertible, raise the hood. On top of the metal support frame at the headlight assembly, there are two screws that hold the full head light assembly to the frame. Remove the two screws. Now the headlight assembly is loose and can be pulled out far enought to remove the lamp. Turn the lamp holder counter closckwise about a half turn or so and remove the lamp. Replace all in the reverse order. Don't touch the new lamp with your bare fingers. Oil from your skin will cause the lamp to turn black.
A 2001 Chrysler Sebring does not have a cabin filter.
go under hood reach down where headlight is turn the light counterclock wise and pull bulb out then twist bulb and it will come out.
Chrysler sebring ignition damage by thief key doesn't work how do you replace?"
No, the 3.2L will not fit a Sebring.
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
2004 Chrysler Sebring headlight bulb replacement: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the headlight bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
You have to remove the entire head light assy. 2 or 3 screws located right above the light. If you have the owner's manual, consult it while doing the above. See sources and related links below for bulb information.
60.00 $
Replace the crank sensor located on bell housing of trans.
That'll be a bulb from inside the engine compartment, behind the lamp.
It will cost between $300.00 to $500.00 to replace the rack and pinion on a 1996 Chrysler Sebring. This cost includes labor and parts.
It would be very expensive considering that car doesn't have a carburetor.