first you must remove the belt using a 15mm and breaker bar on the tensioner. drain all of the fluid out of the reservoir. i have used a shop vac and a tube long enough to reach the bottom of the reservoir to drain the fluid out. then you must loosen both of the lines attached to the pump. once you have removed both lines, then go back to the front of the pump and remove the 3 bolts holding the pump against the motor. pull the pump out through the bottom of the truck and then repeat steps starting with last one first to replace. use atf+4 to fill reservoir.
It will take approximately 1.5 hours to replace the power steering pump in your 2000 Dodge Durango. The exact amount of time will depend upon the person that is doing the repair.
When changing or adding fluid to a car a person needs to have the right type of fluids as well. A 2000 Dodge Durango uses ATF+4 as power steering fluid.
Unlike some transmission fluids, power steering fluid is not manufacturer specific; any high quality power steering fluid will do.
It is in the pressure line just behind the pump.
i never knew such thing ok
um that is hard to say
the contol valve is in the housing the input shaft is connected to the valve
Replace the power steering pump.
It's built into the power steering reservoir. To replace it you need to replace the whole reservoir. Fortunately, this is an inexpensive part... ($30).
Take it to a garage.
What does the 20 amp power outlet fuse do on a 1999 dodge durango
Were is the power window fuse and/or circuit breaker located in a 1999 dodge durango?