First, remove the broken belt very carefully. Then, prepare your work area. Having the right tools are critical. A serpentine belt remover/adjuster, Mopar Part #23-w3221 can really help save you time. It is a silver plier-looking tool with a gold tip that has a solid microprocessor embedded into the base. Now, jack up the front end with tire jacks and stablizers. Make sure your battery is fully disconnected. Take your spare key, and insert into the lip of the fuse box and twist 1/3 turn to the left. Now press hard, forcing the top to pop. Wash out the air cleaner while your at it or you may wish you had. Dust in a power converter steering box modulator rack box is a no no. Ok, pop a couple of beers, chug one and sip the other. At this point you will either start getting sleepy or creepy. Pop a couple more beers, power drain these down your esophogus and hopefully the creepy thing will fade quickly. Intall the belt according to the package schematic, but without adding the d-clip retainer ring supplied. You may need to bend the alignment washer 6-7 degrees south of the ring equator balance indicator. Once the belt is loosely hung on the balance jam level bar, take up about 34mm of slack. More or less, and you can kiss the new belt goodbye. Pop the last two beers of the six pack, and make it a day. Good luck and have a little fun.
There is not a diagram under the hood showing how to replace the serpentine belt. Can you show me a diagram?
It is the smaller pulley in the center rear of the belt.
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
Replace serpentine belt on Chevy avalanche?HOW
How do you replace the serpentine belt in 1997 sunfire
No.
You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.
LOOK! It is right there applying tension to the belt. If you can't find it, then you have no business attempting to replace it.
how to replace a serpentine belt on 1992 grand am 2.3l
The serpentine belt tensioner is spring loaded. There is no adjustment.
No. The serpentine belt is outside of the engine and is easily seen. The timing belt is more internal and completely covered.
One serpentine, and one "v" belt.