0
to replace the starter remove the neg battery terminal then remove the left exhaust pipe bolts.and nuts Push the pipe back as far as possible, then remove 2 starter bolts and drop it down...remove the connector and 12mm nut and wiggle pry pull out the starter...good luck
I just finished installing the starter on a 2000 Trooper and it is not nearly as complicated as the above answer would have you believe. The hardest part will be to remove the two bolts that hold the starter in place. You will need a universal adapter on your socket wrench and a long extension. Use either a breaker bar or a 12" long piece of pipe on the end of the ratchet handle to remove the bolt as they are "really on there"! Once the bolts are removed you can fish the starter out of the small space without removing anything else, like the exhaust pipe or shielding! I did this from underneath the SUV and in less then 2 hours.
I agree, it's really not that hard. I elected to remove the cross member from the frame. It's only four bolts. Once it is out of the way, it is a straight shot to the two bolts that hold the starter on. This also makes it easier to get to the nut that holds the positive lead to the starter. The only other thing I did is to remove a little sheet metal cover just in front of the clutch slave cylinder. I then just wiggled the starter out. I was actually surprised how easy it was after read several posts on the web.
thx dudes i was gonna beat my wifes japaniese junk to peices thx from Tennessee
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
2000 trooper won't start only clicks.not battery?
either replace starter or starter contacts if it is a Nippendenso starter you can try Toyota just have the starter number they my have same starter in the Tacoma's or Camery. Which also carries Nippendenso starts
How do you replace a starter in a 2000 Dodge Intrepid?
I need detailed information on how to replace a starter for a 2000 dodge intrepid
How do you replace a starter in a 2000 Toyota Sienna?
How to replace a starter in a 2009 toyota sienna
How do you replace Hyundai Elantra 2000 starter?
find the location of a 2000 hyundia elantra starter
Check a starter for a 2000 Mercury Grand Marquis?
how to replace starter on 2000 mercury grand marquis
How do you replace a starting ring gear on 1992 Isuzu trooper?
Take out the transmission and there it is. The flywheel holds the ring gear for the starter. If your ring gear has been obliterated by your starter you have an issue with how the starter engages the fly wheel to begin with. Proper clearances, alignment and securing of your starter will make your trooper whole agian.
How do you replace a starter in a 94 trooper?
Disconnect battery, remove electric wires from starter, remove mounting bolts, install new part in reverse sequence.
How do you replace a starter in a 2000 dodge 1500 pickup?
disconnect the battery, un bolt the starter and replace it then connect the battery
How do you change a starter part on a 2000 Chevy venture?
What is the easiest way to replace the starter motor on a 2000 chev Venture?
How do you remove 95 Izuzu Trooper starter?
How do I get the starter out after I dropped it
How do you change a starter on a 1998 Isuzu trooper?
From what I understand, you have to diconnect the exhaust system on the side that the starter motor is located on. To reassemble you have to replace the exhaust gasket with a new one. If you are replacing the starter, there is a GM starter that is a direct replacement for the Isuzu starter and costs quite a bit less.
How do you replace the starter on a 2000 Nissan Altima?
The starter is located beneath the throttle body. Remove the intake tube, then the starter bolts can be removed and the starter replaced.
