0
How do you replace the tail light bulb on a 2002 Chrysler Sebring?
Wiki User
∙ 16y ago
"Pull the trunk liner? If so, what a poor design! " I just did it yesterday. The tools needed are a flathead screwdriver and pliers. Surprise, pulling the trunk liner IS what you need to do. When you remove the push pin properly you can reuse it to put the trunk liner back. You should see three plastic wing nuts and the harness connection to the tail light assembly. You need to remove these to take out the assembly. When you do be sure not to remove the other wiring. The socket for the bulb needs to be turned about 60 degrees and it should come right out. Take out the old bulb and put the new one in. The store sold me a packet of dielectric to put on the terminals to help protect them. (It was $1.00 so why not?) Replace the bulb socket in reverse to the way you took it off. Replace the assembly as it was originally in. Put on the wing nuts and reconnect the harness. Replace the liner and you're done.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How to replace push rods on a 2002 Chrysler sebring gtc?
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
Where is the cabin filter on a 2002 Chrysler Sebring?
A 2002 Chrysler Sebring was not built with a cabin filter.
Where is the maf sensor on a 2002 Chrysler Sebring convertible?
A 2002 Chrysler Sebring convertible does not have a maf sensor.
Is there a 2002 Chrysler cirrus?
No, in 2002 the Chrysler sedan was a Sebring.
Oil pressure light in 2002 Chrysler Sebring 6-cylinder?
The 2002 Chrysler Sebring six-cylinder engine oil pressure light alerts the automobile operator when the oil pressure is too low. The oil pressure light will illuminate red.
How much does it Cost to replace a starter on a 2002 Chrysler Sebring?
Depends on where you get it done but was $365 for me. Yuck!
Where is the brake light switch on a 2002 Chrysler sebring?
On a bracket, above the brake pedal.
Can you replace a 2.7L engine in a 2002 Chrysler Sebring convertible with a 3.0L from a same year Chrysler Sebring coupe?
It is not a direct swap. They use different transmissions, computers, wiring, etc.
Where is the MAF Sensor located on a 2002 Chrysler sebring sedan lx?
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
Where is the stop light switch on a 2002 Chrysler sebring?
It is on a bracket, just above the brake pedal.
Ignition switch will not turn Replace?
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
What engine will have the same wiring harness and motor mounts as the 2.7L out of a 2002 Chrysler Sebring?
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.
