0
If its a 6 cylinder, the water pump is very easy its closest to the front passanger side. Remove the pulley and theres a few 10mm bolts remove them ,remove the water pump and clean the area and reinstall the new pump. Its a 20 minute job.
remember to drain your antifreeze other wise it gets a little messy!
One should remove the belt first by releasing the tension from the tensioner pully.
The trick is to remove the four bolts holding the pulley in place. There is a special tool. However, you can hold one bolt while lossing another. Then use two of the loose bolts as leverage for the last bolt
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you remove a starter in 1998 Chevy Malibu?
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
How do you replace the power window motor in a 1999 Chevy Malibu?
How to replace a window and regulator on a 1998 checy malibu?
How do you fix the front brake pads on a 1998 Chevy Malibu?
Replace them.
1998 Chevy Malibu repair manual?
fuel systemfor 1998 chevy malibu
How do you replace a water pump on a 1998 Chevrolet Malibu?
take it to a mechanic
How do you locate the computer you a 1998 Chevy Malibu?
location of ecm on 1998 Chevrolet Malibu
How many miles can you put on a 1998 Chevy Malibu?
I had a 1998 Chevy Malibu and it lasted for 228,000 miles before it died. Mike, Colorado
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine?
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine
How do you install a water pump on a 1998 Chevy Venture van?
how hard is it to replace a water pump on a 1998 chevy venture van?
How long should it take to replace a engine in a 1998 Chevy Malibu?
I just swapped one out in roughly 24 hours
How do you program a new switch in Chevy Malibu 2001?
1998 chevy malibu programe new switch
Can you put parts from a 1999 Chevy Malibu in a 1998 Chevy Malibu?
YES. Alot of parts will interchange.
