disconnect the battery for 45mins, with the doors closed. After 45mins reconnect the battery and open the drivers door and you should hear a beep. your ecu will be reset. then take it out for a drive trying to keep to around 2000-2500rpm for the ecu to calibrate to the parameters.
for ecu reset must disconnect cable battery for 45min and reconnect battery cable and start the engine
ECU defekt.
under the ecu
lick my shaft
computer's code
remove the centre console and its under there, around the handbrake
to my knowledge the 206's are all fuel injected, so the cold start is controlled by the engine ECU.
207 will not start 1.4 hdi above radio it says ecu fault
What about it? If you want to know where it is, remove the centre console from around the handbrake and its under there.
A similar car to the Peugeot 206 is the Peugeot 205 which the Peugeot 206 is modeled after with minor modifications and upgrades from the Peugeot 205 to the Peugeot 206.
No, as far as I can see it does not.
Disconnet the battery overnight in case the ecu has a back up. Reconnect it in the morning open the drivers door if you hear a beep its reset itself.