conect the ten pen and ground pin on the diagnostic tester with a jumper wire and turn on ignition do not start count the flashes from engine light to get the codes.
What are the head bolt torque specs for a mazda mx3 1600
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
you have to bypass the ecu by bridging a wire in the diagnostics box from the ten port to the ground port then you can turn the distributer and with a timing light set it to 10 before tdc
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
This is done the same as the 1995 Mazda MX6. The answer is posted.
waste of time
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
To ground yourself while getting out of the car, its so you don't get shocked from touching the door while getting out.
Yes,
By regulating the fuel pressure
what size is the motor 1.8 liter
its on the fire wall