If you turn around a corner and you hear a grinding or clicking noise coming from the front wheels, you may have a CV axle problem. This grinding or clicking will be much worse when turning one direction than turning the other. If the noise is worse when turning left, the right CV axle is to blame, if the noise is worse when turning right, the problem is in the left CV axle.
For a bad wheel bearing, you must raise the vehicle so the wheels are off the ground... Grab the tire firmly and try to wiggle it around. A bad wheel bearing will have a lot of play and will wiggle around, a good wheel bearing will be solid and will have very little or no play.
You can if you take the bearing completely apart. There is no nipple
how do I get to the front bearing on a geo 4 wheel drive
2. front left and front right.
you have a definete wheel bearing problem. have it replaced asap
To change a front wheel bearing on a 2002 Alero, secure wheels with a chock. Loosen lug nuts and lift the wheel?æwith a jack. Unscrew lug nuts and remove the wheel, the brake caliper, cotter pin, and castle nut. Remove the rotor and the hub bolts. Disassemble the hub assembly, remove the wheel bearing, and replace with new.?æ?æ
there is no front shaft in 63 impala Wrong answer, it's about two feet from the transmission to the carrier bearing
The front wheels on a fork lift are load bearing and the drive wheels.
No,NO,NO, The NUT that's on the front axel is what holds the WHEEL BEARING TOGETHER. IT has to be there.
Rear wheel drive the gear lube in the center also does the bearings. Front wheel drive the back wheels can either be greased as you would a front wheel bearing or they may be a sealed bearing that can't be greased.
Most front wheel drive bearing hubs can not be greased. --thats ridiculous, your wheel bearing HAS to be greased. you either buy it in a package pre-greased or you BETTER do it yourself ! especially front wheel drive. replacing a wheel bearing is a CHORE, why do it twice becasue you didn't grease it when you fixed it ?
From my research on the Internet , the wheel bearing assembly needs to be replaced. Most likely both of them while you are doing one.
Need to know if it is 2 wheel drive or 4 wheel drive.