A sand filter has laterals (plastic tubes with holes in them) in the bottom, covered with a foot or more of sand of a particular size grain. Pool water is flowed onto the top of the sand and vacuum pressure draws the water through the sand. The particles in the water are trapped in the upper level of the sand and the clean water flows through the laterals and back to the pool. As the dirt builds up on the top of the sand (the schmutzdeck) the filter actually cleans better. Once the dirt layer is thick enough to impede the flow of water, you have to remove it by backwashing. You do not want to backwash too often or you will lose the efficacy of the filter. Be sure to shut off the pump before you move the lever to backwash or you WILL crack the laterals - requiring a very expensive repair.
how do you clean jacuzzi sand filter, and replace sand
distinguish between slow and rapid sand filter
Nothing if its a sand filter However if sand is coming into the pool from the filter then you may have to replace one ore more laterals in the sand filter as they have worn and are letting sand through to the pool,
Do you mean how do you install a sand filter?.
This is a bad idea. Diatomaceous earth (de) will go right through a sand filter. It will end up back in the pool and then it is almost impossible to get out. Sand goes in sand filters, de goes in de filters.
YES it should be no problem
differentiate between slow and rapid sand filters
If you have a sand filter the laterals in it may be starting to show signs of wear these wil blow sand from the sand filter into the pool when they wear out.
Your filter will tell you on the side of it how much media sand to put in it.
If you are getting sand coming into the pool and have a sand filter you may have to replace worn laterals in the sand filter.
Water and a filter would work. Pour the salt/sand into water and the salt will dissolve. Pour the mixture into a filter and the sand will be trapped in the filter. Evaporate the water and the salt will remain.
My Hayward sand filter doesn't have a liner. I just add the sand to the pressure vessel.