generally speaking, there are several LED lights on the battery charger, when the light is red, it meas the battery is being charged, when the light turn to green or yellow, it means the battery is full charged
The difference between a 2amp, a 4amp and a 6amp battery charger is the speed at which the battery will be charged. The numbers represent the maximum amperage output at a specific voltage at which the battery will be charged.
Electric golf carts operate from a DC voltage supply which is supplied by batteries. These batteries have to be charged on a regular basis. The voltage the battery charger operates on is governed by the manufacturer of the battery charger. Check the nameplate on the charger to see what voltage AC is required. Usually the chargers operate on 110 volts, but in some high capacity chargers they will operate on 220 volts. The nameplate will tell you what voltage is needed to operate the charger. That depends on the charger being used. Either is available.
No. A 12 v battery will actually have a charged peak voltage of 13.54v or 13.58v. A six volt charger will have around a max 7.5v voltage. The 6v charger will think the battery has peaked and will discontinue charging.
No, you can not charge a 3V battery with 12V charger.
The answer depends upon the construction of the 6 volt battery. If you can treat it as two 3 volt batteries then the answer is YES otherwise NO. Charge each section separately inserting a low wattage torch bulb between the charger and battery cell to limit the current. Choose the bulb to prevent execissive charging rate; an ammeter would come in handy. The main risk is EXPOSION if you charge too fast! Put the battery to be charged inside a strong box for safety. If in doubt buy a new battery charger, they are cheap.
The meter on your battery charger will be in the green
Most good battery chargers are automatic and will stop charging when the battery is fully charged. But if the charger is a manual charger it can overcharge the battery. With this type charger it is up to you to remove the charger when the battery is fully charged. Normally this is based on the amount of time the charger takes to charge the battery pack. Operators manual will list the time.
Yes, a 12 volt battery will be damaged if charged with a 24 volt charger.
You cannot charge a battery without a battery charger or having it charged by the alternator in your vehicle while it is running.
because there are cells shorting in the battery
Charge it with a 12 volt battery charger.
A battery float charger is intended only to keep a fully charged battery from losing its charge. It will NOT work to charge a battery that is discharged or damaged. Check the voltage of the battery to be charged. Do not use charger if the battery voltage is less than 9.6 volts.
It depends on the charger. The one I have, all you do is hook up the red clamp to the red pole on the battery, the black clamp to the black pole, then plug the charger in to an outlet. The charger has a gauge on it that tell you when the battery is fully charged. I don't know where to hook the charger
If the charger has a ammeter on it then it should show close to zero which means the battery is no longer pulling any current from the charger which would mean the battery is fully charged. If it has only a voltmeter then it should show 12.5-13.5 vdc
Any 12 V battery charger will charge a motorcycle battery. But it is best to get one with low amperage such as a 4 to 6 amp battery charger. You can use a trickle charger to keep the battery charged on my motorcycle during storage.
There is no only one way to charge it and that is with a battery charger. A 15 amp battery charger will charge it about as fast as it needs to be charged.
In 24 hours it will be charged enough to start the car. You really need a much larger charger for a car battery.