0
Drill and tap it for what?
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Is a Remington Model 514 .22 rifle made to be fitted with a scope?
Yes, but you have to drill and tap.
What is the drill size for 8-32 sti tap?
For a cut tap the correct drill size is a #17 drill, which has a diameter of .173 inches.
What diameter is a 12 24 tap drill?
Common references list the tap drill for a #12-24 screw as #17 or .173"
What is the name of the drill bit used before drilling the main hole?
It is not a drill bit, it is called a Tap. You drill a hole slightly smaller than the Tap and then screw it into the hole.
How do you take off a stripped bolt from hub bearing to a brake rotor?
You can use a small drift to tap it loose OR drill it out.
What is the acronym for the immediate action drill for a M16A2 rifle?
Sports(which stands for; Slap, Pull, Observe, Release, Tap and Shoot)http://www.armystudyguide.com/content/army_board_study_guide_topics/m16a2/m16a2-study-guide.shtml
What drill bit size for .125 in. national pipe thread?
Use 7/64 as tap drill and 9/64 as clearance drill
Can you drill out a tap with a carbide bit?
No, you need a special tool with 2 points that lodge in the flutes of the tap.
What class of jig would normally be used to tap holes?
Drill Jigs are used to tap holes.
What size drill bit for a three quarter tap?
2,3mm
What is the diameter of the tap drill for a 1 inch 8 UNC threaded hole?
7/8 diameter drill or .875
What do you do when you break a bolt that attaches the thermostat housing to the engine?
You drill the bolt out that is snapped off in the engine,with drill bit made to drill through metal. Then use a thread maker,tap. Auto parts stores carry these. I no u can get at autozone. The tap makes new threads.
