0
How long does it take to put a knock sensor on a 2000 villager mercury?
Wiki User
∙ 14y ago
Several hours at least. The entire intake manifold must be removed, along with ancillaries. The cooling system must be drained.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What years inner change with a 2000 mercury villager knock sensor?
1999 - 2002.
Donde esta colocado el knock sensor de la mercury villager 2000?
donde esta colocado el knock sensor en una Chevy silverado 2000
Is crank sensor and knock sensor on 2000 villager same thing?
no, it is not.
What is the function of a knock sensor on a 2000 mercury villager?
the knock sensor monitors preignition,spark knock and sends signal to pcm,pcm responds by adjusting ignition timing and fuel timing until knock is gone.
Is there more then 1 CKP sensor on a 2000 Mercury Villager?
No, there is not.
Where is the fuel temp sensor on a 2000 mercury villager?
There is no such part.
Where is the knock sensor in a 2000 villager?
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Where is the outside temperature sensor located on a 2000 Mercury Villager?
In the engine compartment
Where is location of speed sensor on 2000 Mercury Villager?
The speed sensor on a 2000 Mercury Village is found on the transmission of the vehicle. The sensor will be placed on top of the unit to read the rotations of the transaxle.
Where is the speed sensor on a 2000 Mercury Villager?
On the top of the transmission housing at the back corner.
Where is fuel temp sensor a circuit located on 2000 mercury villager?
There is no such part that I am aware of.
Where is speed sensor on 2000 mercury villager?
The vehicle speed sensor is at the top rear corner of the transmission housing.
