This can not be answered with the information you have given. 60Hz does not relate the the current draw so wire size can not be calculated.
Your 2-wire system is actually connected to one "side" of the 3-wire system. In your utility's 3-wire system you have 2 hot wires that are attached to each end of a tranformer winding and the neutral is attached in the middle and grounded. Typically in the US this gives you 240v (or something similar) between hot leads and 120v from each hot lead to neutral or ground.
A multimeter, also called a VOM, is an ohmmeter, ammeter, and voltmeter combined in one case. A function knob can be turned to select the type of measurement to be made, such as volts, amps, or ohms. The multimeter's test lead connections to the circuit will depend on whether you are using it as a voltmeter, an ammeter, or an ohmmeter.
A mains lead is the power cable for the strip heater. The mains lead is single-insulated.
lead
Put the black lead into any of the black connectors on the molex.put the read lead into the yellow, or red lead on the molex.
An extension lead is an electrical cable which allows one to use a plug-in device away from the wall-socket.
Hair extensions Extension lead House extension
An extension lead has a plug on one end and a few sockets on the other end. They are used to reach appliances that are far away from the main sockets. It is very safe to use an extension cord as long as you don't overload them.
try your local cooperative extension
Behringer amps are electric guitar amplifiers. They are used to amplify the sound of the guitar. There are different models for bass guitar and lead guitar.
depends on the kind of aux on the amp or the lead of the headset
my plays in a band and is a lead guitar player, my concern is can he continue with this and do amps create any problems
Follow your heart, it will lead you to the right decision
I normally lead wipe the lead to lead connection using flemico #1 Warrenteed bar solder. If you cannot get flemico try getting 40/ 60 solder in bar form then lead wipe it
You would need a source of power giving at least 500watts to heat a cup in reasonable time. You could obtain this from a lead acid cell such as a car battery. At 12v you would need a current of say 50 amps (this would give 600watts). So the heating coil should have a resistance of 12/50 ohms = 0.24 ohms. The connectors to and from the battery would need to be rated for 50 amps without heating up appreciably.
Dollar diplomacy was an extension of the Roosevelt Corollary in the sense that Roosevelt tried to eliminate European
Dollar diplomacy was an extension of the Roosevelt Corollary in the sense that Roosevelt tried to eliminate European