answersLogoWhite

0


Best Answer

In a typical home, the surface flooring (such as wood, carpet or vinyl) rests on a subfloor, which rests on joists -- a series of closely spaced parallel beams that support the floor or ceiling loads. Joists are usually supported by a sill (a long horizontal timber that's the lowest part of the framework and rests on the foundation) or a girder (a large beam that's the main support of the building). When replacing rotted floor joists it's important to be sure the girder and sill are still intact.Typical costs:

  • If only a few joists are rotted primarily at the bottom, they can be repaired using a process known as "sistering" -- after the rot is cleaned away and the timber treated to prevent more problems, a new joist is laid beside the old one and fastened to it. Total costs will depend on the extent of the damage and the ease of access to the joists (through a basement or crawlspace), but in general sistering averages $100 -$300 or more per joist, and could run $1,000 -$3,000or more to repair a tilted, wavy or bouncy floor under an average room.
  • If the floor joists are extensively damaged, it will be necessary to support the house with jacks while the joists are removed and replaced. In many cases, the sill may also be rotted and need replacing. Costs can run $10,000 -$30,000 or more for a typical home, depending on its size, the extent of the extent of the damage and the ease of access to install jacks and replace the timbers. If the damage is limited to just one section of floor joists, the project could run $5,000-$10,000.
What should be included:
  • Joists carry the weight of walls, furniture, people, appliances and anything else placed on the flooring they support. Usually wooden floor joists are 2"x8", 2"x10" or 2"x12" timbers -- their size depends on their length, the amount of "load" they're designed to carry and the building codes in effect when the house was constructed. The Family Handyman explains how joists work.
  • If there is sufficient access through a basement or crawlspace, floor joists can be repaired or replaced without significant impact on the rest of the house. However, if there is limited access, all furniture and appliances must be removed from the affected area and the flooring and subfloor torn out. The Family Handyman explains how to "sister" damaged joists and HammerZone.com describes using a jack to raise a slightly sagging floor.
Additional costs:
  • Floor joists can be damaged by boring insects such as termites or extended exposure to water. Before you replace damaged floor joists, you must exterminate the insects or improve the drainage and ventilation so the problem won't reoccur. Costs will vary widely depending on the extent and nature of the original problem.
  • Typically floor joists are repaired or replaced working from below, in a basement or crawl space. But if there's limited access to the joists, it may be necessary to work from above, removing the flooring and subflooring to repair or replace any damaged floor joists. Costs will depend on the extent of the damage and the type of replacement subflooring and flooring chosen.
User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the cost to replace a rim joist?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you insulate Rim band joist in the basement?

Usually with a piece of insulation fitted between the joist, top of the foundationand the floor.


What are the ends of the joist nailed too?

Floor joist or ceiling joist? Floor joist have a board on the end all the way along the side of the building called a rim joist. Like the cross bar on the top of a T. Ceiling joist are nailed down into the top plate of the wall and to the rafters where possible.


How do you replace a rim on a MTD Log Splitter?

Your best bet is to just just buy a new tire & rim combo rather then trying to replace the rim only. The amount of work and cost wouldn't be worth it.


How much of a gap is left between each end of the floor joist and the web of the rim joist to prevent squeaking?

No gap is intentionaly left. Your squeaking will be between the subfloor and joists.


Is a rim joist necessary?

AnswerIt is a sill (sills: the horizontal timbers of a building) which rests on the foundation, meeting the ends of the joists--(a plain old "joist" is one of the set of parallel timbers beneath the floor boards that run from one side of a building to the other).


Can you change a tire if the rim is welded on?

If the rim is welded to the tire, yes. You can change it, but you have to replace both the rim and the tire which will cost a lot. If the rim is welded to the vehicle itself, no. You cannot change it. In either case, having a welded rim is technically illegal in the US if you drive it on the road. If you don't, then it's not a problem


How do you spell rim?

yes. the 'rim' of a cup is the edge of the cup.


Rim band joist in the basement are a poor place to insulate?

The rim or band joists in the basement are a bad place to insulate because it will cause the floor above to always be cold. Heat rises, and any heat in the basement from the furnace unit will rise and help warm the floor. Insulating will trap heat in the basement.


How can you put a tire back on the rim?

Take the tire and the rim to a tire shop. It requires special equipment to properly replace the tire and balance the rim.


How do you repair deck joists on a cantilever deck?

Not knowing if the joist are in need of repair from rot (deterioration) or broken/damaged then replace ment of joist may be necessary. First get a replacement joist of the same or better species and treatment content and dimensions as the existing joist. Then cut the joist to the same length. You may have to cut a small angle on the bottom end of the joist to aid in working it over and between the girts and decking boards. Work the joist within a few inches of the joist to be replaced. Use a short 4x4 to drive the joist or a wood block to strike with a hammer. Take a couple of scrap 2x's and temporarily fasten to the girts and new joist to prevent movement. Then you may try a couple methods to remove the old joist. If the decking is fastened with screws then simply backout the screws. If it is nailed, then a 10 lbs. hammer can often remove most anything you need and is a great stress reliever but I recomend you use a reciprocating saw to cut the fasteners between the joist and decking. Usually the vibration of the saw and nails being cut will loosen the deck side of the fasteners and allow you to go top side and pull the old nail halves out. Once the old joist and fasteners are out you can carefully work the new joist in place. I recommend fastening the old decking to the new joist with properly coated screws or a hotdipped galvanized rink shank nail. Repeat joist replacement as necessary on other joist.


What can be a word sentence of joist?

A joist is a beam, a supporting structure in a building. The roof joist was riddled with dry rot and had to be replaced.


How much weight can you put on a floor joist?

it depen on the size of the joist