around 2000 for both head gaskets and around 1000-1500 for one side only
its a convertable
My experience was that the "spider gasket" inside the multi-port valve was unseated and allowing blow-by. Replace the gasket.
There is no such thing as a ferrari spyder or spider. Spider just means it's a convertable. There are ferrari 458 Spiders and ferrari 430 spiders, but they are no where near as fast as a Bugatti Veyron
spider gasket is bad
The spider gasket in your valve may be deteriorated. Buy a spider gasket and some silicon grease at your pool store. Remove the screws in the multi-port valve and replace the spider gasket after you thorough cover it wth grease. To keep this from happening again, never add chlorine through your skimmer. Always use a floater if you use tablets or install an off-line chlorinator as far away from the filter as possible. Hatawa
Check that your filters valve is set to filter. The second thing to check is your spider gasket inside the multi-port valve (see below). If you have a sand filter that is more than ten years old, you may have to change out the sand due to tunnels that form with time through dirty sand. If you have a DE filter you may have a hole in one of the grids. The spider gasket in your valve may be deteriorated. Buy a spider gasket and some silicon grease at your pool store. Remove the screws in the multi-port valve and replace the spider gasket after you thoroughly cover it with grease. To keep this from happening again, never add chlorine through your skimmer. Always use a floater if you use tablets or install an off-line chlorinator as far away from the filter as possible. Hatawa
Replace the spider gasket inside the filter valve. This is simple to do and should be done every couple of years, especially if you have an in-line chlorinator or if you add chlorine through your skimmer. Make sure you grease the gasket with silicon before you install it. To keep this from happening, make sure you have a check valve installed between the filter and the chlorinator or use a floater to chlorinate your pool.
You could try poolcenter.com ANSWER:: And the problem begins. Do you have the right tools for removing the valve parts? Some valves require specialty tools. Another problem is how do you seat the "spider" gasket. Most glues, caulking compounds do not hold. It may be less expensive -- cost effective -- in time and frustration to replace the entire valve. Even the manufacturer will balk at revealing the glue that they use. Also will you be able to get the gasket seat clean or dry enough? A pool store may be able to special order the spider gasket. Expect to wait a while. K
Be sure the O-ring gasket around the spider housing is new, on correctly and lubricated with oil. Also lubricate the opening in the upper intake where the spider is inserted. It should fit firmly.
the difference is that the f430 is a hardtop and the spider 430 has a soft top convertable, and the f430 is actually called the f430 coupe, and finally the f in f430 actually stands for ferrari so you dont have to say 'f'430.
It really depends on the spider. Any ordinary house spider should not make you sick.
Yes, of course. I buried a spider with my brother once.