Be sure the O-ring gasket around the spider housing is new, on correctly and lubricated with oil. Also lubricate the opening in the upper intake where the spider is inserted. It should fit firmly.
No. This means that the manifold has an exhaust leak.
The bell housing is the front part of the trans that goes around the flywheel.The bell housing is the front part of the trans that goes around the flywheel.
firewall to the right side of the motor (facing motor) around the front and one goes to the thermostat housing and the other goes down behind the intake manifold to the lower hose. They are not directional.
No there is not a water jacket in an intake manifold they are around the cylinder walls in the engine block.
The housing gasket may be bad. Replace the gasket.
around 6-7 hours according to AllData
It should be located around the throttle cable at the carbuereator or fuel injection cable on the top center of your motor. Close to where the fuel enters the intake manifold. Basicly a few screws to remove or the module it self should screw off easily according to what your working on.
Collagen periurethral injection is a procedure in which collagen is injected around the urethra and bladder neck as a treatment for stress incontinence in women
You have to remove the part of the exhaust manifold that wraps around the driver's side of the engine, which is no easy task! The thermostat housing is behind that manifold. There is a small cast iron pipe leading out toward the radiator with a radiator hose attached to it. Follow that iron pipe in toward the engine, and you will see where to remove the two bolts to get to the thermostat. The designers did not think about the auto owner on this one.
The location of the IAC valve depends on the kind of fuel injection system you have. On the Vortec V6 (93+) it's right on top of the air intake in front of the throttle valve. If you follow the air intake tube to the motor, the IAC valve will be in the intake manifold right where the air tube meets the manifold. The wiring for the IAC valve comes around behind the throttle cable bracket and plugs into the IAC valve.
You figure at about $13,000/year for 26 injections (1 every other week), one injection is around $500.
right around the exhaust manifold