Yes, the cable that came with the xbox 360 was just a standard ethernet cable.
No, i didn't want to spend the money so i just bought an internet cable and ran it from my x box 360 to my internet router for a fraction of the cost. This is asumeing you have internet in your home.
Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it. Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it. Look on the top of the transmission. The shift cable attaches to a "box" with a wire harness attached. That's it.
This might be a cable for some additional feature your car is not equipped with, but the wire is included in the standard cable assy
The pre wire for a ceiling fan light should be made with a three wire cable. This cable will have a red, black, and white wire as main conductors. This cable will also have a bare ground wire. This wire should be strung between a two gang switch box to the fixture junction box. This pre wire allows the supply to be either fed to the two gang box. From the two gang switch junction box, one side will be used for the light in the fixture and the other side of the switch junction box, itwill be used for the fan portionin the fixture.
Replace the cable with a new one. Or the cable might provide you with a new one. Ask them for a service call.
You will get the cables in the Xbox 360 box. You will not get a HDMI cable so you will need to buy one of them.
yes you do its a grey cable that comes included in the pack
The antennan wire on your HDTV will connect to the back of the television set, if it is antenna compatible. The wall cable will go to the audio in location where you connect the coaxial cable. A digital antenna converter box will be needed to make the television work without a true digital signal coming into the home.
No <<>> The NO answer above pertains to a metallic or PVC conduit system. In home wiring, with the type of wire being used it would be near impossible to drag a cable through a switch or receptacle junction box without cutting the cable. Once this cable is cut, the grounds have to be spliced together and this ground wire is then required by code to be grounded to the box.
In the Kinect box, you will see another cable. This cable is useless if you have the Xbox 360 s. However, you need this other cable to connect the Kinect to an older Xbox 360 model. This cable is an power supply, also the USB for the Kinect. If any problems, you can get a guide on the Xbox website about this. Or just look in your manual.
You need a XSATA Hookup/cable or an Xplorer 360 Hookup/cable.