Take your vehicle down to the local AutoZone or parts store and have them check the voltage output of your alternator. If it's to low/high, this will cause your light to stay on.
There is no reset for the battery light. If the light is on there's a problem with the electrical system and once the problem is repaired the light will automatically go out.
There is no reset for the battery (charging system) warning light. It is on because there is a problem. Once you repair the problem the light will go out. More than likely the alternator has failed.
when you disconnect your battery and reconnect it will reset cumputer
Fix the problem it indicates and reset it by unhooking the battery.
There is no reset for the charging system light. If it is on then you have a problem. More than likely the alternator is defective.
Have the problem repaired and they will reset the light. If you DIY then disconnect the negative battery cable for 5 minutes. If that does not reset the light you will have to have it reset with an OBD2 scan tool.
The battery warning light illuminates when the battery isn't being charged , get it checked out to find the problem and then repair.
reset battery no charge light after battery replacement.
I changed the battery and voila' - no more light.
There is no reset for the light. The light is on because you have a problem with the charging system. Once the problem is corrected the light will go out. Normally the light comes on when the alternator stops functioning.
Did you reset the light? I don't know what gasket you changed, but undoubtedly that was not the problem. The check engine light comes on when there is a problem with the emissions system.
Disconnect the battery cable for about 10 minutes and the light will be reset. If it comes on again after driving, it's a recurring problem and you can get the codes read and hopefully fix the problem. Disconnect the battery cable for about 10 minutes and the light will be reset. If it comes on again after driving, it's a recurring problem and you can get the codes read and hopefully fix the problem.