0
Yes, you can pick a simple lock in either the unlocked or locked position. There isn't much difference in the actions between the two.
Additional Response:
When a lock is unlocked, there are no more pins to manipulate. All one has to do is turn the cylinder inside the kik (Key in Knob) housing, and it slides into place. You can use a pick, you can use a fingernail file, you can use pressure on the outside of the actual cylinder and just turn it with your finger.
An unlocked cylinder - in all cases that I am aware of at least - has the pins separated and the bottom pins aren't even touching the kik. There's no resistance present, so yes, it can be "relocked" with a pick. It can also be relocked by putting your finger on it and spinning it a little bit.
There are no pins to manipulate in order to "relock" any lock I have ever encountered - and I've seen quite a few.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you reset a factory installed alarm on a 2000 Chrysler Grand Voyager?
Use the remote door lock to lock the doors, then unlock, then lock. The alarm should be reset. If not get in the vehicle, lock all the doors with them closed, unlock them, relock them walla alarm reset!
What doors can you pick in resident evil outbreak file 2?
First of all, you can only pick lock with Alyssa. Second of all, you can only pick the lock of the doors that read "It's locked by a simple lock." Those are the only doors that you can pick lock.
What is it called when you open a lock with a crowbar?
Pick Lock
How do you use a tubular lock pick?
Essentially you set the picks in a tubular lock pick to "past flush" meaning they extend beyond the housing they're normally inside. Once there, press them flush by pushing the pick down on a table or other flat surface. Next, tighten the collar of the tubular lock pick. Once the collar is snug, place it in the key in knob cylinder for the lock. This should "impression" the required key onto your tubular lock pick. Extract the pick slowly while turning it, and you should open the lock. You should also be left with the calibrations for that lock's key on your pick, which will enable you to duplicate it or simply reset your pick the next time you want to pick that lock.
How do you pick combination lock?
You don't. By definition a combination lock has no key, and thus there is nothing to "pick." Picking a lock refers to mimicking the role of a key in a lock. A combination lock has no key, and thus cannot be "picked."
Can a sidewinder snake pick a lock with its tongue?
No. A snake's tongue is not strong enough to pick a lock. Additionally, snakes aren't smart enough to even know what a lock is, let alone pick one.
98 Chevy Express door lock electrical stays on lock constantly and won't disengage Disconnected each lock button still relay set on lock Any advice?
take out the fuse that causes these locks to relock...should be on the drivers side, underneath , about 9 oclock position...if not should be under hood fuse relay box no its not
How do you pick a 3 number luggage lock?
You don't. By definition a combination lock has no key, and thus there is nothing to "pick." Picking a lock refers to mimicking the role of a key in a lock. A combination lock has no key, and thus cannot be "picked."
How do you pick a mailbox lock?
Picking a mailbox lock involves inserting a tension wrench and a lock pick into the lock, applying light rotational pressure with the tension wrench while moving the lock pins with the lock pick until they align and the lock turns. It is important to note that picking a mailbox lock without permission is illegal and could result in criminal charges.
How to turn off real axle lock on jeep rubicon?
I assume you mean rear axle lock... The axle lock function works as follows: Push the switch in once to lock the rear, twice to lock the front as well. Then pushing the switch will unlock/relock the front. With just the rear locked, pull the switch twords you to unlock the rear. Or you can move the transfer case lever to 2WD, which will disengage the lockers.
Which tools are included in a lock picking set?
The tools that are included in a lock picking set are a torsion wrench, a half-diamond pick, a hook pick, a ball pick, rake picks, a slagel pick, a decoder pick, a warded pick, and bump keys.
Will UnJailbreaking Relock your iPhone 3g?
no if it is ulcoked that is permanent
