There are to oxygen sensors on a 2004 Chrysler Sebring. They are located on the right side of the engine, against the firewall. Sensor 1 is located in front of the catalytic converter, and sensor 2 is located behind it.
So far I have found 1 o2 sensor pre-cat underneath the driver area. I have located 2 post-cat o2 sensors (one behind each cat). I know there is another pre-cat o2 sensor that I'm misssing somewhere. Can somebody please help us out here? Thank you.
Boss and HON make excellent computer chairs that are both comfortable and sturdy. For tips on how to select an office chair, visit http://www.overstock.com/guides/Tips-on-Selecting-a-Computer-Chair
O2 SENSOR is on the exhaust behind the engine, closer to the firewall. theres is 2 sensors one you can reach from the bottom of the car the other from the top.
There are two in the exhaust pipe on either side of the catalytic converter.
whee is the coolant sensor location in a 1999 Cherokee classic]
i believe its located somewhere on the exhaust
The oxygen sensor is screwed into the exhaust before the catalytic converter.
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
A person can get a 2004 PT Cruiser engine diagram from a Chrysler dealership. An auto parts store also may have a copy of the diagram for customers.
The gas cap is loose or there is a large vapor leak in the fuel system.
Did you ever have a coolant leak?
If you have it done by a dealer, probably around $200. The alternator itself can be purchased for about $80.00, but, if you don't know how to install it yourself you can expect to pay for an hour labor. Depending on the shop that can run from $50.00 to 100.00 per hour.
No, it shouldn't.No, it shouldn't.
Chrysler PT Cruiser was created in 2001.
The external air temperature sensor on a Chrysler PT Cruiser is located in the front of the motor. It is in the air intake tube that goes from the air cleaner to the motor.
No. The Chrysler PT Cruiser was stopped in 2010.
No. The Chrysler PT Cruiser was built from 2001-2010.
Replace both of them.
Chrysler manufactures the PT Cruiser
It is on the engine, just below the radiator cap.
cost me $200 , which included camshaft sensor
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
There are two screwed into the exhaust on the rear of the engine .
It is on the driver side end of the cylinder head.