Did you flush out the valve body prior to installing the new cartridge
The ball very seldom is the problem it is the springs and cap washers
The o rings inside the cartridge have become either faulty, worn or perished. You need to replace the cartridge for you to solve this problem.
If it is a full stream, you put the cartridge in reversed. If it is just a drip, you may need to polish the bottom of the cartridge where it contacts the new cup. The metal plate on the cartridge can rust or have mineral build up on it. If it is the older style with a flat washer on the end of the stem, sometimes the seat the washer closes against can be pitted.
They did in 2006.
Some cartrides are hot/cold specific. The hole that allows the water to pass thru the cartridge will not close because you can't turn it far enough. Some cartrides are hot/cold specific. The hole that allows the water to pass thru the cartridge will not close because you can't turn it far enough.
If the sprayer hose screws onto the faucet, you can get a cap for that fitting. If it pushes into the faucet, I do not believe there is any plug available for that type. You have to have something on the hose fitting or water will come out when you turn the faucet on.
Maybe you should ask your doctor for a referral to a sinus expert.
Proably the faucet has a worn out washer, replacing the washer should fix the problem.
They still make a .32 caliber cartridge.
Delta Faucet Co. isa company owned by Masco Corporation out of Detroit, MI. In 1971 Masco introduced the Peerless Faucet for the DIY market. The design of the Peerless Faucet line is almost identical to the Delta Faucets and the internal parts are the same. I do believe that Peerless Faucets are still owned by Masco Corporation.
What type of faucet is it? Is it two taps, or one, Twist to turn on/off, or push/pull? It is a one handle, twist on/off type faucet.
If you change the ink cartridge without letting the printer driver reset, it will think you are still using the old ink cartridge. Install the cartridge again using the "install new cartridge option". If you follow these directions you should not have a problem.