answersLogoWhite

0


Best Answer

The belt is loose and needs adjusting, or it is worn out and needs replacing.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Motorcycle drive belt squeaks
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the advantages and disadvantages of a motorcycle belt drive compared to a drive chain?

Belt drive is quieter, but can be damaged by stones caught between belt and sprocket.


What is wrong when my car squeaks during acceleration after it rains?

almost always belt grease or don't drive through big puddles! try some dawn or belt dressing on your belts


First year harley-davidson belt drive?

The first Harley belt drive was on the original motorcycle built in 1903. But it was a flat leather belt driving a pulley bolted to the rear wheel. The first modern toothed rubber drive belt was on the 1980 Harley's.


What is wrong with your car if the air conditioner squeaks when its turned on?

Possibly the accessory belt needs tightening or replacing -or- the bearing for the drive pulley may be going bad.


Do you have a picture of the timing belt on a 1999 kia sportage?

No, but have you ever seen a motorcycle that used a drive belt rather than a chain. Well the belt look just like your timing belt.


Can you change your shaft drive on your motorcycle to a belt drive?

You will need to change the gearbox, swing arm, back wheel and, probably, brake arrangement and shocks.


Is a motorcycle belt drive smoother than a shaft drive?

Ok the shaft drive is smoother as long as the shaft and bearings are maintained properly the belt drive will be close to the same smoothness but will have a slight vibration due to the design of the pulley teeth or cog and the belt tooth contact area. and the belt needs adjustments more often. hope that helps


Why would a belt for the alternator keep breaking and always squeaks?

Check the alignment of belt in relationship to all pulleys. Check the condition of the pulleys. Also make sure the belt being replace is the recommended size. Auto shops have belt measuring tools to check the size of the belt before installing into your vehicle. You may have had a belt installed that was too large in the first place. The squeaks are a sign of a loose belt or a belt not recommended for your vehicle.


What is the solution for a '96 Dodge Neon that squeaks loud periodically when air is on?

Replace or tighten the A/C belt. If equipped with a serpentine belt, replace it.


Can tires squeak?

Yes, a "slipped belt" can cause a tire to squeak. A slipped belt is when the belt area of the tire separates from the radial plies of the tire and there is a noise as the two parts rub across each other. If a tire squeaks because of a slipped belt, do not drive at high speed and replace the tire as quickly as possible. A slipped belt will eventually separate causing the tire to blow out.


What is a motorcycle belt drive?

"Belt drive" refers to the type of final drive from the gearbox to the rear wheel. Traditionally, bikes have a chain & sprockets. More recently, some manufacturers have replaced the chain with a belt on some models. The belt works in exactly the same way as the chain, and some say that belts are harder wearing than chains. (They are certainly less likely to develope tight-spots).


What are the uses of a belt drive?

A belt drive is an alternative to a chain drive (as you would normally find on a bicycle or motorcycle). There are several types of belt used in belt drive systems including V-belts and toothed belts. The more common is the V-belt. A cross section of the pulley used shows that the belt runs in a V-shaped groove. Washing machines, older cars, and machinery use this type of belt system. The toothed belt is normally wide and flat with teeth on the inside to prevent slippage. Harley Davidson motorcycles use these, as do super-charged engines in cars.