I have the same problem. have you managed to have any luck yet?
You might need to programming the remote. Their should be instructions in the users manual. You're remote could also be need new batteries.
-I was to;d that only the dealer can do it.They need to send to Germany for a new code and then they reprogram the remote.
You might need to re-programming the remote. Check instructions in the users manual. The remote could also be need new batteries.
The system will reset when the proper key is put in the ignition and turned on.
Resetting a Viper immobilizer can be quite tricky if you do not have the manual for it. If you hl down both buttons on the remote for five seconds and it doesnt reset you will need to call the manufacturer.
the battery died in my remote. After replacing it the auto start will not work. What are the steps I need to take to reprogram it??
The system will need to be reset or repaired. To reset a original GM system start by using the remote lock and unlock the doors. Then have a repair shop scan the computer and see if it can be reset. If that does not work it will need to see a GM dealer or qualified repair person.
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
might be keys need to be recoded. Others with the same problem use the remote to reset it. im haveing same problem(but we dont have remotes). will let you know what the dealer says.
No you need a mii remote
Unplug the television from the outlet. Wait for approximately three minutes. This will reset the television to the original factory settings. You will need to allow the television time to search for channels, but this will rid you of the PIP without the remote.
To program your universal remote, you will need to know the brand of remote that you own. Once you have figured that out, go to the website of the manufacturer, and they will have instructions listed on how to program your remote.