0
The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you remove the radiator in a 2006 Chevy Cobalt?
with the correct tools
What cylinder is number 2 on a 2006 Chevy Cobalt 2.2 engine?
From Passenger side to drivers side, 1, 2, 3, 4.
How do you check for power to the fuel pump on a 2006 cobalt?
cobalt 2006 fuel pressure pump
What makes key not turn to lock position on a 2006 Chevy Cobalt?
If the battery is dead it will not allow the key to return to locked position. Thus trapping you key in the ignition.
How do you install tail light bulb Chevy Cobalt 2006?
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
Replace grill in front bumper 2006 cobalt?
How to replace front middle grille in a 2006 cobalt ls
How do you remove the ignition switch on a 2006 kawasaki ninja 650?
remove the front cover, disconnect the turn signals wires and the two nuts that whole the gages, then down under the ignition switch and remove the two Allen screws and disconnect the wiring. install your new one ignition switch in reverse to the instructions.
How do you remove the radio trim from a 2006 Chevy Cobalt?
all the trim panels are held in by clips and they just simply snap off
How do you remove window crank on 2006 cobalt?
place flat screwdriver behind and pry outwords repeat around hole crank.
How do you reset the change oil soon light on a 2006 Cobalt?
turn the ignition key on (don't start) and depress the gas pedal 3 times within 5 seconds.
How charge the battery in a 2006 Chevy Cobalt?
Open your trunk, remove the carpet as if you are getting to the spare tire and the batterie is located there, remove it with a socket wrench and take it to your local autozone for charging.
Where is the IAT sensor located in good detail on a 2006 Chevrolet Cobalt 4-cylinder?
I have a 2008 Cobalt 2.2 and it has came to my conclusion that the IAT sensor and the MAF sensor are integrated together. they are the sensor that plugs into the intake tube about 3 inches from the air cleaner box.
