Get some wood wedges and hammer them in between the grille and hood just enough to get a wrench to reach the bolts on the hood striker. Remove the striker bolts and the hood will be able to be lifted open.
Open the hood as far as you can then use a flat-blade screwdriver to pust the latch. Just remember to always carry the tool and a flashlight to locate the latch.
have someone push down on the hood then pull the hood release
I own a 92 with the same problem. You have to gain access from underneath with a socket wrench and long extensions to take off the top part of the release that is mounted to the underneath of the hood. I have the cable dropped down with a plastic "T" Handle tied to the end of the cable so that I can pull the release until I can find a replacement cable. I have been looking but have yet to find one. Hope this helps
Take a flat screw driver and use it to push the spring away from the hood latch. Locate the screw driver at the end of the cable. This works for mine.
You have a vacuum hose disconnected or broken. Check under the hood for a small vacuum hose out of place or broken.
Open the hood, prop it open and read the stickers that are applied to the underside of the hood. All that sort of pertinent information can usually be found there.
Open the hood and its located on the passengers side near the firewall.....
It depends on where its broke at. Is the cable broken at the mechanical part or is it broken before that?
The plastic inside door handle is probably broken.
hey there, i had the same problem, but i figured it out! and now I'm gonna help you! grab a screw driver or something like that (thin, "pokey", and not easily broken), I used a SPOON! haha. right under your hood in the middle in the front, well actually slightly to the right and up a little bit theres a "loop" kind of thing. you need to push it back with your spoon or whatever you are using. that will open the hood as if you pulled the "hood release" lever in the cab, then all you gotta do is reach your hand in there and grab the handle that is slightly to the left of the middle and open it all the way. ________________________________________________________________________ .........................................L ____ m*____|.................................................... ________________________________|_______________________________________ (L) is the hand lever (m) is the middle (*) is the thing you gotta push kind of a crappy diagram, good luck!
yes
Check under hood for a broken or disconnected vacuum supply line.