only if it is connected to another heat source such as electric strip heat and are having problems with the heatpump. other wise you will get a big surprise when your utility bill comes in the mail.
Only if the outside unit is a heat pump.
i set my thermostat to cool, my heat pump start it go to heat but not cool, i think the thermostat. can u help.
Emergency Heat [EM] should only be used as a backup if the heat pump fails. EM heat uses 1.5 to 3 times as much or electricity as the heat pump.
A programmable thermostat works fine with a heat pump. Just remember that a heat pump does not heat as fast as a furnace because of the lower BTU ratings so do not set the thermostat as far back as you normally would. Also make sure to buy a thermostat that has heat pump terminals.
It is because your thermostat is taking time to warm up. It should eventually rise up to the temp. that you set it as.
A device for regulating furnace heat is the thermostat. A programmable thermostat can be set to control the temperature inside the home on a regular schedule. The thermostat is set to a desired temperature and then the furnace turns on and off to accomplish the desired heat level.
No.
If you have a Heat pump, you must set the thermostat up for "heat pump". Then you must connect all the wires up according to the manual. If you do not have a heat pump, the wiring may be crossed or touching somewhere. Call a local heating and air conditioning company to trace out the problem.
In the instruction manual for the furnace, it will either give you the heat anticipator setting or instruct you how to do it. If its digital, well then follow the thermostat instructions
Heat pumps don't work well when its below freezing point temperature's
When the heat in an oven can not be controlled it is the fault of the oven's thermostat. It is the thermostat that opens and closes to maintain a set point temperature. Depending on how the thermostat failed it will give the results of the oven always being on, oven with no heat whatsoever or when the calibration is not set correct, when wrong temperature is maintained.
The wattage of electric base board heaters does not change because the thermostat is set on low. The wattage is a fixed value on the heater because of its internal resistance element. The thermostat set on low shuts off at a lower temperature than a thermostat that is set on high. It is the time interval that governs the amount of heat that the heater produces when the thermostat calls for heat. Once the room heats up to the temperature that the thermostat is set at, the heater shuts off. The thermostat is just a temperature switch.