Substitute a test light for the fuse and remove each socket and bulb until test ligh goes out that will tell you which area is shorted to ground Then you can replace socket, wiring, etc in that area only
yes just push the emergance brake one click.
Brake lights and turn signals are on a separate circuit from the tail lights. Tail lights are on the same circuit with the dashboard lights. If the dashboard lights aren't working either, check the fuse. If they ARE working, check the headlight switch.
If the instrument gauge fuse blows on your 1997 Suburban, you might have an issue with the wiring. An exposed or grounded wire can cause the fuse to blow each time the panel is engaged.
May possibly be in the multifuction switch on the left of the steering column!!!!
check the brakelight switch. it is located under the dash where the brake pedal rests. Hey its ritchie. If you can click your blinker down and then they work its you blinker switch,but this is my monte.
dot. 3 fluid.
Brake light fuse
Answer Usually when the flasher blinks rapidly it's about finished. Try replacing the signal light flasher and see what happens. If you still don't have Brake Lights start looking for a short.
are brake lights staying on or is brake in the dash on ?
check your clutch and brake fluid
The bulbs are burnt out.
are you sure it is the brake lights and not the tail lights. if it is the brake lights you most likely have a short some where. go to a auto eletrican It is the brake lights which turn on. Short in the switch or the wiring?