New cylinder head bolts are required and an angle guage,or you can make one up with card and a set square. Head bolt torque is 25Nm(newton metres)+60degrees + 60deg + 60 deg so it's a four step process.Con.rod bolts(big-end)28Nm,Inlet manifold 28Nm,Exhaust manifold 25Nm, Crank pulley 40Nm,Sump 5Nm and use locking compound (loctite)Timing cover 6Nm. Valve clearance,set inlets to .006" and ehausts to .010"(set approx.when cold then re-adjust while warmed engine is idling.Good luck.
What are cylinder head bolts torque settings for Isuzu kb240. Engine NAQ001716
what are the torque settings for a mitsubishi 4m51 engine
polo torque settings 1200 engine main bearing
30 NM 50 NM then 90°
help
25nm then 3 x 60 degrees
torque settings are: 4JG2 cylinder head, 49 Nm + 60 degrees + 60 degrees.
You need to specify which torque settings. As with any vehicle, torque settings are specific to a particular part of the vehicle.The torque settings for the cylinder head will differ from the settings for the crankshaft bearings.
the Haynes manual says cylinder head bolts are 80 ft-lbs
The 2001 Jeep Cherokee 3.7 liter engine cylinder had bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
60 nm or 44 pounds then give it 90degree turn
The 1993 Chevrolet nova 1.5 liter engine cylinder head torque settings are 120 pounds per square inch. The cylinder head bolts should be torqued at 40 pound intervals.