The light bulb in this case will explode(burn) do to the natural tendency of the charge of the bulb with the voltage reacting at constant current.
anything from a little smoke from a heated component to a violent and dangerous explosion be careful with electricity if you want to shock someone give them a 5 dollar bill!
An active device is a device that takes input energy to operate. The only energy a diode uses is from the signal applied to it (it has one input, one output, and no other terminals), so it is a passive device. To be an active device, a separate power source must be applied to it - such as the case for operation amplifiers, for example.
A method for the CPU to communicate with the device, Software to instruct and control the device, and Electricity to power the device.
Ohm's law: Voltage = Current times Resistance Solve: Resistance = Voltage divided by Current So, a device drawing 50ma with 150V has a resistance of 150 / 0.05, or 3000 ohms. p.s. Since power is volts times amps, that device is dissipating 7.5 watts.
You exceed the power dissipation capability of the device and it burns up. Too much voltage across the terminals , too much current being passed through it, reverse voltage spikes can all cause the triac to "blow".
Yes, it is an instrument for recording. A microphone is a sensor device that converts mechanical pressure waves or sound in air into electrical voltage waves. Speaking into a microphone excites (moves) a diaphragm that is coupled to a device that creates an electrical voltage proportional to the produced sound pressure.
-- Apply a small, known voltage between the terminals of the device. -- Measure the current through the device with the voltage applied. -- Calculate the resistance of the device. It's (voltage) divided by (current).
No, twice the voltage applied to a device that only requires 6 volts will probably destroy the device. When a manufacturer of equipment states a required voltage for a device that is the voltage that must be used.
A: As the reverse voltage is applied to the SCR increases at a certain point the device will start to conduct that is defined as the breakdown voltage for that device
No the low voltage is not harmful for all ever . if you applied low voltage than the output power of your device will low and you can also observe that the performance of your device will also reduce. it may also make the device inactive.
the voltage which is mainly applied to primary side of the transformer is called rated voltage.Answer'Rated voltage' is the nominal voltage at which an electrical device has been designed to operate.
Line voltage is understood as the voltage that the device or appliance needs to operate on. It is also referred to as the devices working voltage. Once the proper line voltage or working voltage is applied to the device it may be transformed to different voltages for different internal component circuits.
a device which output voltage is almost the real peak valueof an applied signal
A voltage, or potential difference, is what causes current to flow through a circuit. So all devices (called 'loads') require a voltage applied to them.
Voltage or current Offset is the voltage or current seen at the outputeven when no input is applied. This happens due to various reasons such as imbalance in the device, asymmetry and many more. So, offset adjustment means, providing the required input externally, so that the output voltage and current are zero.
since in an FET the value of the current depends upon the value of the voltage applied at the gate and drain...so it is known as voltage controlled device.. for example..in a mosfet..the current from drain to source depends upon the width of the depletion layer..which in turn depends upon the voltage applied on the gate.. so that is the reason
The thyristor functions in such a way that when the anode voltage is greater than the cathode voltage , it is not triggered but only triggers when a gate signal is applied at the gate of the device.
the answer is Rectifier. it converts ac voltage into dc which can apply to the dc device