microphone
An opamp buffer circuit is one where the input signal is connected to the plus input, and the output is connected to the minus input. Within the performance limitations of the opamp, the output will track the input. The advantage of the buffer circuit is that is presents very little load impedance to the input signal, while providing a low impedance from the output to drive whatever circuitry is connected there.
10 megohms is the resistance through which 10 volts would push 10 microamps of current. Input impedance is the resistance seen by a signal source when connected to the input Often, this means there is a 10 megohm resistor in series with the input going to a virtual ground on an opamp circuit. 10 megohms is a common input impedance for a digital voltmeter.
Because op amp consist differential amplifier and they posses high input impedance so that op-amp also posses high input impedance.
Output impedance in an op-amp is not high - it is low - input impendance is high, and this is because the input stage transistors have high gain.
opamp is a device used to amplify ac as well as DC input signals. It is called as operational amp becoz it is used to perform all mathematical operations. Symbol of opamp indicates the direction of current.
The output voltage of a opamp when the input of inverting and non inverting terminals are grounded
An opamp is a circuit of many components. It may either be built of many discrete components or be a single integrated component.
If you go to the given link you will see the circuit of a current mirror using Op-Amp. And you can easily see how it is biased.
An op-amp, or OPerational AMPlifier, is simply a pre-built transistor amplifier circuit on a self-contained integrated circuit chip (usually one chip holds multiple op-amps)
yes, with additional circuitry. an opamp wired as a differentiator followed by an opamp wired as a comparator can provide short timing periods. an opamp wired as an integrator followed by an opamp wired as a comparator, plus some other circuits left as an exercise to the reader can provide long timing periods.
The (Class C, Common Collector) Emitter Follower is used to amplify the available current from a voltage driving circuit that might be disturbed by the load impedance. If the actual voltage value is important, the emitter follower is often teamed up with an opamp which sets the emitter voltage based on the input voltage.
A comparator is simply an opamp with a certain configuation of external circuitry ( a few components) that make it function as a comparator.