DNS and DHCP Management are both Administrative Tools.
DNS Management is run from the DNS MMC snap in.
This can be accessed by using the Run commend, and inputting: dnsmgmt.msc
DHCP Management is run from the DHCP MMC snap in.
This can be accessed by using the Run commend, and inputting: dhcpmgmt.msc
These snap-ins must be installed on the system, or you will be unable to access them.
DHCP has to be configured by using the DHCP snap-in MMC console. This is under the Administrative Tools once DHCP has been installed. In Windows Server 2008 you add the Role, so it isn't installed via the Control Panel at all. For configuring the scope, you need to specify the address ranges to give out, any exclusions, and scope options for default gateway, etc.
Admin access. Generally there are DHCP settings to control the distribution of IP addresses. It varies from device to device.
DHCP itself means Dynamic host control protocol... :)
Turn off dhcp in router settings.
A. The PTR resource record.
Yes, DHCP usually assigns a number of settings for an adaptor, which may include: IP Address Subnet Mask Default gateway WINS servers DNS servers and other settings.
router(config)#ip dhcp pool pool nameRouter(dhcp-config)# network x.x.x.x y.y.y.yx being the networky being the subnetOther settings are available for configuration.
Either go into the network settings and change it, or have the setting changed in the DHCP server settings.
DHCP and configured as part of a workgroup.
The Dynamic Host Configuration Protocol, or DHCP, is responsible for IP assignment and DNS settings. It also assigns network settings and provides network configuration information including subnet mask and broadcast address.
Usually only one. A DHCP server is a Dynamic Host Control Panel, which assigns an IP to a network device. It will only give you one, and everyone using that network device will also have the same IP.
The DHCP server is not a member of the DnsUpdateProxy security group.