smm
Will a Socket 478 Pentium 4 fit in an LGA775 socket?No. The pinout is totally different. Technically, LGA775 is not even a socket. The LGA775 actually has the pins sticking UP, and the processor is flat.Will an LGA775 Pentium 4 work in an LGA775 socket?Yes. However, support for Pentium 4s was discontinued in the P35 and later chipsets.Are there adapters to fit a Socket 478 Pentium 4 into an LGA775 socket?Yes. These are expensive, though, making it much more worthwhile to purchase an LGA775 P4 in the first place.
You can use any LGA775 Pentium 4, Pentium D, or Celeron D with an 800, 533, or 400 Mhz FSB.
3.0 GHz Pentium 4s were manufactured for both Socket 478 and LGA775.
This would all depend on your actual motherboard. Some boards do take a Pentium 3 chip. If you know the model of your board, then check the manufacturers website, for details of the maximum mhz allowed for it. If you don't know the model number, then go to Google, and download a program called belarc advisor. Once installed, this will give you the in's and out#s of your PC. All hardware, and software installed. If you find the board does take a Pentium 3 CPU, then you will need to purchase a 'slotty'. Basically this is a piece of hardware, that turns the black CPU, into a normal CPU. It slots inside the same place as the original CPU. With the added advantage of a heatsink and fan, which can be plugged onto the board. Hope this helps be safe
That depends upon the socket type the processor was made for. The Pentium 4 was released in three socket types: # Socket 423 (423 Pins) # Socket 478 (478 Pins) # LGA775 (775 Contacts) Note: in the case of the LGA775 the processor does not have pins. Instead it has contacts, while the socket actually has pins that connect to the contacts on the processor.
Not necessarily. There have been three different sockets used for Pentium 4 processors (Socket 423, Socket 478, and LGA775). They are not interchangeable without special adapters. Even when pin-compatible, motherboard updates may be necessary for the processors to actually work.
it is a microprocessor produced by Intel. You have not provided sufficient information to determine what core or manufacturing process it was produced on, nor what FSB speed it uses. Most likely it uses Socket 478 to connect to the motherboard, rather than LGA775.
The CPU can be upgraded only if your motherboard/chipset and BIOS support it. Socket 478 motherboards cannot support a Dual-Core, as they use a different socket. If you have an LGA775 motherboard, it may work, but chipsets before 945 are not officially supported and may fail to function properly.
No! The Asus P5Q PRO Turbo motherboard has the Intel LGA775 processor socket, which supports the Intel Core 2, Cerleron Dual-core, and Pentium Dual-core processor families. Your FSB (Front Side Bus) speed is also too slow for the Core I7 CPU.
I7 Processors use socket LGA775.
The E6600 uses LGA775.
If you have an older Socket 478 Pentium 4, the cooler will not fit properly. If you have one of the later LGA775 P4s, it should work, as Pentium Ds actually output more heat than a Pentium 4. But a cooler only rated for, say, a Core 2 Duo, without the Pentium 4 being taken into account, would not work, since Core 2s do not generate as much heat under full load.