www.oehq.com
The heater temp blend valve is located behind the dash assembly. The dash assembly must be removed to gain access.
The heater control valve (temp blend door) is located behind the dash assembly. The dash assembly has to come out to gain access to it.
Behind the dash assembly inside the HVAC assembly. The dash assembly needs to be removed to gain access to it.
Behind the dash assembly, big job for the faint at heart.
Yes, the heater temp blend door actuator is located behind the dash assembly, on top of the heater box. The dash assembly must be removed to gain access to it.
The heater temp blend door actuator is located behind the dash assembly, attached to the top of the HVAC box. Unfortunately, the entire dash assembly must be removed to gain access.
The heater core is located inside the HVAC (Heating, Ventilation and Air Conditioning) box which is located behind the dash assembly. The dash assembly must be removed to gain access to the HVAC box.
It does not use a cable. The heater blend door is operated by a electric motor. The complete dash assembly needs to be removed to gain access to the unit.
Drain the engine cooling system into a clean container for reuse............Remove or disconnect the following...........Negative battery cable Heater hoses from the heater core Instrument panel storage compartment Electrical connectors, as necessary, that may be in the way Center floor air distribution duct Hinge pillar trim kick panels Blower motor cover screws and the cover Blower motor screws and the blower motor Steering wheel and the steering column Instrument panel fasteners and pull the instrument panel back far enough to gain access to the heater assembly Screw located on the interior side near the evaporator pipe, if equipped, while holding the heater assembly against the firewall 4 heater assembly-to-chassis screws and the 2 heater assembly-to-chassis nuts, working in the engine compartment7 heater cover-to-heater assembly screws and the cover Heater core from the heater assembly
how to instill a deluxe heater in a 55 chevy
Drain the radiator. Disconnect the heater hoses. Remove the screws holding the heater core case and remove the whole assembly. Remove the core and install the new on in the case. Reverse the procedure to finish the installation.
The block heater cord is on the Engine Block Heater on the 2007 Chevy Optra.