I don't know about the manual, but I just figured out how to clean it. Lift the blade, wiggle it a bit counter-clockwise... once it comes off then twist the top off. It was easier to wiggle the blade off before twisting the top... but it was a bit of a struggle. Once its off you will see the latches under the blade, making it easier for next time. Hope it helps.
It is such a simple machine, I doubt a manual would exist.
The marlin model 50 and model 50e do not use an extractor. There is only an extractor pin/post. Try these sources: Numrich gunpartscorp.com Jack First jackfirstgun.com Bob's Gun Shop gun-parts.com Some versions of the model 50 do indeed have a manual extractor. It sets in a slot in the side of the rifle, just ahead of the bolt handle slot. I suppose it's main use is to extract an unfired round. Many are lost and never replaced. I'd sure like to find one
NUmrich has the extractor, But no sling
yes
Best left to a gunsmith
Best to let a gunsmith do it.
The Remington Model 7400 extractor is a semicircular shaped part made of spring steel that is held in its correct location with a rivet. This rivet needs to be properly staked in place and blended with the outside diameter of the bolt head. This is a job that should be done by a competent gunsmith that has the correct equipment to do the job properly. The model 7400's extractor was changed from the earlier model 742's which as noted above was riveted in. The model 7400 has a snap in extractor - no rivet. I replaced mine by inserting a curved tool (I modified a small thin screwdriver by bending the tip) through the magazine well under the extractor to pull out the remainder of the old extractor, then snapped in the new one. The new extractor cost 20 dollars (with shipping and tax) from Remington.
Gun Parts Corp www.gunpartscorp.com
e-gunparts.com
I've got them. sales@countrygunsmith.net
There's been bikes sold under the Raleigh name for years and years. Which extractor you need will depend on the actual model, and not the make of the bike.
The extractor for a model 170 Savage Arms 30-30 can be purchased through Numrich catalogs. You can also find this part in the Brownell's catalog available at many gun stores.
yes you can go to numrich.com they have tons of parts