underneath dash near steering column attached to linkage from master cylinder
Remove the fill cap and add it at the brake fluid master cylinder reservoir. Located on or near the master cylinder.
I have finally located the brake light switch module on our 2005. It is located on the cross bar just in front of the rear Axel. There are three modules clipped together. The module for the brake lights has three air lines in it. One big red one, a smaller green line and a smaller orange line. Hope this helps.
Dot 3
Most likely cause is a problem with the front brake light switch located in the right switch housing on the handlebars. If you installed new levers you may have ones for a different model or the clip that holds the switch my have fallen out.
Hey, I hope i can save you the frustration I had. On the 2005 it is pin two tan/white.
The type of oil that should be used in a 2005 Jeep Liberty is 5W30. You can switch to 10W30 in the warmer months.
Brake lights? Check brake light switch for adjustment or replacement
brake lamp switch failure
most times if brake lights are stuck on you have a bad brake light switch on pedal under dash
Check the fuses, Check the bulbs, Check the brake light switch, In that order.
* Brake light switch * Shorted or Broken wires between fuses and bulb sockets * Poor connection in light socket ... clean them out and put a little vaseline on them
The 2005 Subaru backup light relay switch can be found beneath the drivers side dashboard. The backup relay switch will be above the brake pedal.