Answer
Whenever I replaced my mom's sterio in her '95 it was located behind the panel in the cargo area. It was located behind the passenger side panel. I imagine it is in the same place in the '92 since they were similar models. You have to use a clip removal tool or some sort of flat screw driver to remove the clips on the trim panel and the large panel it is behind. Hope this helps you. Good luck.
On a 1997 Ford Explorer, the stereo amplifier is located above the rear wheel on the passenger side. It can be accessed by removing the side panel.
It is located on the passenger side rear quarter panel.
The amplifier is located in the rear of the vehicle. In the cargo area behind the rear passenger side panel.
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
How do you replace evaporator on a 1992 ford explorer?"
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
Inside the fuel tank
behind the rear passenger seat under the panel of what would be the trunk
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
under the blower motor housing. to the right
The 1992 Ford Explorer uses an A4LD automatic transmission
On a 1992 Ford Explorer : The firewall is the metal wall that divides the engine compartment from the passenger compartment