answersLogoWhite

0


Best Answer

There is two of them,and they are under the Intake manifold.
You will have to remove the intake to even see them and to remove them.
Bad place for GM. to put them.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the anti knock sensor on a 2004 Chevy 4.8 V8?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the anti-knock sensor on a 2003 Chevy Avalanche?

you mean knock sensor


What is the anti knock sensor on a Chevy 350 for?

It signals the computer to reduce the ignition timing.


Where is the anti knock sensor on a Chevy 350 block?

It is in front of the starter on my van.1990 350


92 Toyota pickup v6 engine anti knock sensor location?

89 toyota pickup v6 engine anti knock sensor location


Where is the Anti knock sensor on 1995 Chevy Suburban?

Should be on the passenger side of the engine screwed into the block by the starter. It is below the exhaust manifold.


Diagnosing engine knock in 97 astro van?

check the anti knock sensor on the side of the motor


Can the knock sensor cause overheating and loss of anti-freeze?

Overheating, yes. Loss of antifreeze, no.


What is the wire on the front hub of a 2000 Chevy Tahoe 4wd?

That is the anti locking brake sensor / wheel speed sensor


Where is the anti lock brake sensor located on a Chevy Tahoe?

in front of the wheel bearing your anti lock brake system sensor should be, im having the same problem


Would a blown head gasket make a motor knock?

yes but if it is a blown head gasket it will make it miss and put steam and some water out the tell pipe if its not doing these things then check your anti knock sensor


What is the funniest anti joke?

Knock Knock Who's there James Come in!


Could a anti knock sensor that is unplugged or defective cause problems with the 305 motor starting?

No, a faulty knock sensor will cause a code 43 normally. check for spark, diconnect a wire from a plug, install a plug in the wire, lay it on something metal, have an assistant crank the motor and watch for spark...