I don't think that there is a camshaft sensor on this engine. There is however, a crankshaft sensor that is located on the passenger side of the bellhousing where it meets the engine. It should be just to the passenger side of the distributor. There is s sensor in the distributor that does the same job as a cam sensor.
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.
It is down by or on the distributor
It does not have one. It has a Distributor that controlls that.
Yes, and the rest of the question?
inside of distributor
Camshaft angle sensor (CAS) is on the head opposite of the timing belt. A 95 also has a crankshaft position sensor and that is down below the timing belt. 1G's only had one sensor to do the job of both and 95 and later have two sensors to send info to the PCM.
Is is located inside the distributor.
I'm sure its in the distributor.
behind the power steering reservoir
There isn't one. It only has a dual vane crankshaft position sensor.
Not if you do not repalce it.Not if you do not repalce it.