Dodge Ram Van

Where is the camshaft position sensor in a 95 dodge 2500 3.9?

012

Top Answer
User Avatar
Wiki User
Answered
2014-06-26 09:52:48
2014-06-26 09:52:48

The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.

Camshaft position sensor circuit malfunction.

The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.

Below the injection pump, on the back of the timing cover.

under the rotor in the distributor unplug the wires take off the rotor and pull it out

the cam sensor is under the distributor cap.this engine uses the distributor pickup as a cam reference since the dstributor is cam driven

The throttle position sensor on a 2000 Dodge Ram 2500 Diesel is located on the right hand side of the carburetor. This location is on the driver's side of the motor.

It is located in the rear of the timing gear housing under the fuel injection pump.

It is on the part that the throttle cable hooks to on the engine.

It is called a APPS accelerator pedal position sensor. It is located on the front of the engine. It is the part that the throttle cables hook to.

Gas engine, on the throttle body. Diesel engine, on the injection pump.

The crankshaft position sensor on the V 8 is behind the passenger side cylinder head, mounted through the transmission bell housing. The crankshaft position sensor on the diesel is mounted on the front of the engine, pointed at the crank pulley.

That is the sensor after the catalytic converter.

The engine computer uses the crank position sensor for the tach reading. It is located in the top pass side of the bell housing.

Under the rotor inside the distributor capUnder the rotor inside the distributor cap

my book says code 0123 THROTTLE/PEDAL POSITION SENSOR/SWITCH A CIRCUIT HIGH INPUT

the crankshaft position sensor is located in between engine and trans passenger side. it easy to change . It is in the top of the bell housing on the pass side, under the trans dipstick tube.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.