The Crank sensor is located right above the oil filter (on 2.4) to the left of the starter if looking from the front of the car. Pull the oil filter off. There is a small clip to pull harness out, remove that, then the 10mm bolt that holds that in. The bolt is kinda hard to see and get to, becareful not to strip it out. fairly simple, good luck.
Next to the oil filter, bolted to the block.
THE CRANK SENSOR ON A 97 5.7 IS LOCATED UNDER THE CRANKSHAFT PULLEY BETWEEN THE PULLEY AND THE OILPAN. SLIGHTLY TO DRIVERS SIDE
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
how to i put it at on the Chevy cavalier 2.2 l
how do i remove the upper intake manifold on a 97 chevy cavalier 2.2l v4
"97 Chevy cavalier" radio diagram which wires go where
The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.
The 1997 Chevy crankshaft sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
the clutch went out on my 97 Chevy cavalier how do i fix it
The front o2 sensor is just to the left of the battery. It's a little tube with a wire that is plugged in right before the exhaust pipe.
Is there a certain way to postition the crank sensor on a 97 k1500?
where is the crank sensor located on my 1997 Chrysler sebring lxi