0
Where is the crank shaft sensor in a 1997 sebring convertable?
Wiki User
∙ 15y ago
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What would cause a 1997 Sebring Convertable engine to stall?
check the crank shaft sensor MAP, CRANKSHAFT, CAMSHAFT SENSOR THE COMBINATION OF THOSE SENSORS WILL LET THE CAR RUN RIGHT AND NOT STALL ANY MORE
On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
Where is the crank shaft sensor located in a Audi a4?
Where is the crank shaft sensor located in a Audi a6
Would the crank shaft sensor on a 1999 Chrysler Sebring prevent the car from starting?
Yes, it could along with dozens of other possibilities.
How do you know if your crank shaft sensor is bad?
One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.
Where is the Crank Sensor in a 2001 Malibu?
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
Where is the crank shaft sensor on a 2000 Chrysler Sebring jxi?
The sensor is under the car on the back of the engine on the left side on the 2.4L. On the 2.5L it is on the top rear of the transmission bell housing.
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
Where is the crank sensor located on a 1998 Chrysler Sebring?
A) On a 2.0L & 2.5L DOHC (1999 & earlier) Engines, The crank shaft sensor is mounted above the oil filter. B) On 2.4L DOHC ( 2001 & later) engines, the crankshaft sensor is mounted on the rear side of the engine block C) On 2.5L V6 engines, the crank shaft is mounted under the distributor near the transaxle housing.
What is the Location of crank shaft sensor 1992 Chevy truck?
That year model does not have a crank sensor.
Is the crank shaft sensor part of a tuneup?
No
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
