What would you like to do?
Behind the glovebox there is one panel to remove, then use a small socket to remove the two screws holding in the fan resister card and connector. You will need to lay on you…r back to do this using a light source.
The PCM is located in the actual engine bay on a 2000 Chrysler Sebring. It is mounted vertically next to the battery tray.
The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle…'s computer of its status.
there are two O2 sensors one is on the exhaust just behind the fire wall the other is just underneath the exhaust manifold
It is on the top rear of the transmission bell housing.
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
It is located directly below the distributor. It is on the transmission bellhousing on the firewall side. It is hard to see without some stuff moved out of the way.
On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
On top of the fuel tank held in place by the fuel tank strap. I just replaced the fuel filter and pump-------this is an easy job the second time around. Follow my instructions… to complete the job in less than 2 hours. Instructions will post at a later date.
It has one. It is located on the top rear of the transmission bellhousing.
Just behind the engine, in the passenger side of the bell housing.
On the 2.5L it is under the housing where the lower radiator hoseattaches to the engine.
You can disarm the alarm by unlocking the doors with a key. You can disarm the alarm by unlocking the doors with a key.
Any light on the vehicle that is on all the time, and any relay that is stuck. Also if the battery has a dead cell it will not hold a charge.
A 2000 Chrysler does not have a reset switch. A 2000 Chrysler does not have a reset switch.