0
On crankshaft position sensor, one camshaft position sensor.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
I replaced the cam and crank sensors on a 2006 Chrysler Sebring 2.4 and it still won't start do i have to resync them?
No you do not.
Are there two cam shaft sensors on 2006 dodge stratus with a 2.4l?
No, just one.
Will a Chrysler 4.7 engine from a 2002 ram 1500 pick up truck fit in a 2006?
It would bolt up, but the tone rings inside the engine for the crank and cam sensors are different. The engine would not start.
Where are the o2 sensors located on a 2006 Chrysler Sebring convertible?
Oxygen sensors are screwed into the exhaust on both sides of the catalytic converter.
Where is the crank sensor on a 2006 Chrysler town and country 3.8?
It is on the top rear of the transmission bell housing.
Where are the 02 sensors located in a 2006 Chrysler Town and Country?
The oxygen sensors are screwed into the exhaust on the rear of the engine. The upstream is before the catalytic converter, the downstream is after.
How do you remove your 2006 ford explorer speedometer cable?
there is no cable you have speed sensors located in the tail shaft of the transmission
Where is the speedometer cable in a 2006 Chrysler 300?
There is no speedometer cable. The speed signal comes from transmission and abs speed sensors. Chrysler last used a cable in the 1980's.
What is problem when Drive shaft hits muffler in reverse on 2006 Chrysler 300?
Check the engine and transmission mounts along with the exhaust hangers.
Where are the airbag sensors located on 2006 silverado?
where are the airbag sensors on a 2006 silverado
Why does the PSI sensor keep coming on in your 2006 Chrysler 300 after you put 22 inch rims on it?
You either didn't swap the tire sensors to your new rims, or you damaged a sensor.
Where the output speed sensor on 2006 Chrysler 300C nag1 transmission?
The NAG1 transmission uses the wheel speed sensors (at each wheel bearing) as the output speed signal.
