The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
It is in the passenger side of the timing cover towards the bottom.
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
under the starter
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
It's on the passenger side of the bellhousing.
behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on
in the side of the block, above the started
It is in the side of the block behind the starter.
front of the engine under the crankshaft pulley
Yes, a crank sensor is one of the major sensors used to control engine timing and cylinder firing.
Just behind the engine, in the passenger side of the bell housing.
The engine crank shaft is inside the engine