It is in the side of the block behind the starter.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
Front driver side of the crankshaft pulley.
YesYes
yes gap it at .50 with brass gauge.
It sits behind the starter on the drivers side of the engine. You will have to remove the starter in order to see it.
All that is required to restart a 2006 Cummins is to add fuel and crank the engine. The fuel system is self bleeding.
It is on the drivers side buried behind the starter. You need to remove the starter and then you have access to it.
It's probably the same as a 2001. I assume you are talking about the crankshaft position sensor. It is locate on the driver side of the engine block down low at the rear of the block. The starter has to be removed to remove and replace it.
It is in the side of the block, behind the starter.
It is in the side of the block, behind the starter.
Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.