It's probably the same as a 2001. I assume you are talking about the crankshaft position sensor. It is locate on the driver side of the engine block down low at the rear of the block. The starter has to be removed to remove and replace it.
Front driver side of the crankshaft pulley.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
It sits behind the starter on the drivers side of the engine. You will have to remove the starter in order to see it.
It is in the side of the block behind the starter.
YesYes
All that is required to restart a 2006 Cummins is to add fuel and crank the engine. The fuel system is self bleeding.
No, The pcm has to see a signal from the sensor
yes gap it at .50 with brass gauge.
GAS ENGINE The sensor is mounted on the bellhousing DIESEL ENGINE Bolted to the left rear side of the engine block
crank sensor
where is the crank sensor located on a 6.0l ford power stroke diesel
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.