0
Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
Wiki User
∙ 11y ago
Wiki User
∙ 11y agoLower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
Add your answer:
Earn +20 pts
Where is the cam sensor on a 1989 dodge cummins?
A 1989 5.9L Cummins does not have a cam sensor.
Where is the cam sensor on a 2006 dodge cummins?
Cam sensor on a 2006 Dodge Cummins is found just below the fuel injection pump. It is attached to back of the timing gear housing. It is attached with an Allen head bolt.
Where is cam shaft sensor located on 1993 Dodge Cummins diesel?
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
Where is cam sensor on a 2003 dodge ram cummins diesel?
i been searching for it on my 2004 and cant find it either.
The location of cam sensor in 2000 dodge ram?
Should be under the distributor cap
Is there a cam sensor in 2002 dodge with 318?
A 2002 Dodge does have a cam sensor, but the 318 was not offered after 2001.
What is a cam positioning sensor on a 1997 5.2 v8 dodge Dakota and why is it causing your check engine light to come on?
The cam sensor is inside the distributor and tells the computer the rotational location of the camshaft.
Location of cam sensor for 2005 Scion xb?
what is location of cam positioning sensor on 2005 scion xb
97 Dodge crank sensor And cam sensor location at?
IS this a 5.2, if so the crank sensor is on the passenger side of the engine, in the far rear, it picks up off the flywheel, the cam sensor is located inside the distributor (it is the pick up coil).
Cam position sensor location for 1996 Dodge Intrepid?
Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!
Where is the cam sensor on 4.7 dodge?
The cam sensor is under the front of the passenger side cylinder head.
Where is the cam positioning sensor on a 2004 Dodge Dakota 4.7L?
The cam sensor on a Dodge 4.7L is under the front outside of the passenger side cylinder head.
